---
title: "What Is Portfolio Heat? How Much Total Risk to Carry"
description: "Risk Management, Position Sizing, Swing Trading"
url: https://easyswing.trading/blog/portfolio-heat-swing-trading/
updated: 2026-11-01
---

# What Is Portfolio Heat? How Much Total Risk to Carry

*8 min read | November 2026 | Tags: Risk Management, Position Sizing, Swing Trading*


Ten consecutive 1% losing trades cost a trader 9.6% of equity (1 − 0.99^10 = 0.096). Five correlated positions risking 2% each can cost 10% in a single session. **Portfolio heat is the total open risk across every position you hold, expressed as a percentage of account equity — and it is the number that decides how bad a bad week can get.**

Position sizing controls how much you lose on one trade. Heat controls how much you lose when several trades fail together, which is exactly what happens when a market turns and most breakouts fail at once.

This guide defines portfolio heat, shows the arithmetic with a worked five-position book, lays out heat limits by market regime, and explains the correlation trap that makes a low heat number misleading.

## What Portfolio Heat Means

Portfolio heat is the sum of the dollars you would lose if every open position hit its stop, divided by account equity. A book with five positions that each risk 1% of the account carries 5% heat. A sixth position at 1% moves it to 6%.

The term comes from the risk-management vocabulary of systematic trading. Van Tharp's *Trade Your Way to Financial Freedom* (1998) frames every trade in R-multiples — the distance from entry to stop is 1R — and total open R across all positions is the same idea expressed in trade units rather than percentages. If you hold four trades with 1R at risk each, you have 4R of heat.

Heat is a forward-looking number. Profit and loss measure what already happened; heat measures what the current book could lose from this point if every stop triggers. That is why traders check it before adding a position, not after.

The formula is simple:

Portfolio Heat % = (Sum of open risk in dollars ÷ Account equity) × 100

Open risk for one position is shares × (current price − current stop). It uses the current stop, not the original one, which matters once you start trailing stops higher.

## A Worked Five-Position Example

Open risk is shares times the distance from price to stop. Take a $50,000 account and five long positions. The table shows each position's share count, stop distance, and open risk.

| Position | Entry | Stop | Shares | Open risk | % of equity |
|----------|-------|------|--------|-----------|-------------|
| A (semiconductor) | $40.00 | $38.00 | 250 | $500 | 1.0% |
| B (semiconductor) | $80.00 | $76.00 | 125 | $500 | 1.0% |
| C (semiconductor) | $25.00 | $24.00 | 500 | $500 | 1.0% |
| D (healthcare) | $100.00 | $95.00 | 50 | $250 | 0.5% |
| E (industrial) | $60.00 | $57.50 | 100 | $250 | 0.5% |
| **Total** | | | | **$2,000** | **4.0%** |

Heat is 4.0%. Under the common 1–2% per-trade rule that looks conservative, and in a strong bull market it is well inside a typical limit.

Now trail the stops. When position A rises and its stop moves from $38.00 to $40.00 (breakeven), its open risk falls from $500 to $0. Total heat drops from 4.0% to 3.0% even though no position was closed. Raising stops to lock in gains is the cleanest way to free risk budget for new ideas, and it is why open risk is calculated from the current stop.

The reverse also holds. Adding a new position while four others sit at full risk pushes heat up, and a trader who never checks the total can drift from 4% to 9% one reasonable-looking trade at a time.

## Why Heat Matters More Than Per-Trade Risk

Per-trade risk limits assume losses arrive one at a time. In practice they cluster. When the broad market breaks down, breakout setups fail together, and the positions that looked like five independent bets behave like one large bet.

Consider two traders who both risk 1% per trade. Trader one holds three positions: heat is 3%. Trader two holds twelve: heat is 12%. If the market gaps lower and every stop triggers, trader one loses about 3% and trader two loses about 12%. Both followed the same sizing rule. Only one of them had a heat limit.

Curtis Faith documented the same logic in *Way of the Turtle* (2007). The original Turtle trading program capped exposure at several levels — a limit on units in a single market, a lower limit on closely correlated markets, and a cap on total units in one direction. The structure is a heat limit built from layers: per-market, per-correlated-group, and portfolio-wide.

Mark Minervini has written that he limits risk on any single trade to a small fraction of equity, in a range of roughly 1.25% to 2.5% (*Trade Like a Stock Market Wizard*, 2013), and that he reduces exposure when his recent trades stop working. A per-trade cap and a total cap work together: the first prevents one outsized loss, the second prevents a cluster of ordinary ones.

Gaps add one more reason to keep the total modest. A stop is a planned exit price, not a guaranteed fill. Overnight gaps and earnings reactions can take a position through its stop, so real losses on a bad day can exceed the nominal heat figure. A buffer between your heat limit and the loss you can tolerate absorbs that slippage.

## Portfolio Heat Limits by Market Regime

Heat limits are not fixed. The right ceiling depends on how favorable the market is for the setups you trade, which is why our [position sizing guide](/blog/position-sizing-r-multiples-risk-management) scales risk with the [market regime](/blog/market-regime-bull-bear-choppy).

| Market regime | Risk per trade | Maximum portfolio heat |
|---------------|----------------|------------------------|
| Trending Up | Up to 2% on top-grade setups | 8–10% |
| Ranging (choppy) | 0.5–1% | 4–5% |
| Transitioning | 0.25–0.5%, or stay in cash | 2–3% |
| High Volatility / Trending Down | 0.25% at most, or flat | 1–2% |

EasySwing's in-app risk budget is separate from these reference ranges: its default total-risk cap is 6% of equity with a 4-position cap, and both are user-adjustable.

These are guidelines for a calculator, not instructions. A trader with a smaller risk tolerance should set a lower ceiling in every row. Many swing traders run well below the top of the Trending Up range even in strong markets, because a 10% drawdown takes an 11.1% gain to recover.

The arithmetic of recovery explains the caution. A 20% loss requires a 25% gain to break even, and a 30% loss requires 42.9%. Because losses compound against you, the cost of high heat is not linear: the deeper the hole, the harder the climb back.

The practical routine is to check the regime first, pick the ceiling for that row, and compare it with your current heat before considering a new position. If the regime weakens while you hold a full book, the ceiling drops and you are suddenly over limit. The fix is to raise stops, trim, or close the weakest positions until heat falls back under the new cap, not to hope the regime reverses.

## The Correlation Trap

A low heat number can hide a concentrated book. In the worked example, three of the five positions are semiconductor stocks. Their combined risk is 3.0% of equity out of 4.0% total heat, so three-quarters of the book's risk rides on one industry group.

Stocks in the same group tend to reverse together. A sector-wide sell-off, a rotation out of a theme, or an unfavorable earnings report from a bellwether can trigger several stops on the same day. Counting those three positions as independent 1% risks understates what the cluster can cost.

Two simple controls address this:

- **Sector cap:** limit open positions to two or three per industry group, or cap each group's share of total heat at roughly one-third to one-half of the ceiling.
- **Position cap:** set a maximum number of simultaneous positions. Five to eight positions is a common range for a swing trader holding trades for 2 to 30 days, because beyond that the book is hard to monitor and heat creeps up.

EasySwing's dashboard shows both ideas. The header shows open positions against a position cap and lists sector counts on hover, and the dollar open risk is summed from the positions you log in the [trade journal](/blog/swing-trading-journal). The point is to see concentration at a glance instead of discovering it during a sell-off.

Correlation is not always obvious from sector labels. Names in different sectors can share a common driver, such as interest rates, oil, or a single large customer. When two positions have been moving in lockstep, treat them as one position for heat purposes.

## How to Calculate and Manage Heat Day to Day

A repeatable routine takes about two minutes and prevents most heat drift.

1. **List every open position** with shares, current price, and current stop.
2. **Compute open risk per position:** shares × (price − stop). If the stop is at or above entry, the open risk against your starting capital is zero or negative, and many traders count it as zero for conservatism.
3. **Add the dollars and divide by equity** to get heat.
4. **Compare with the regime ceiling** from the table above.
5. **Group by sector and theme** and check that no cluster uses more than its share.
6. **Decide before adding:** a new position at 1% risk is allowed only if heat after adding stays under the ceiling.

Position sizing for the new trade follows from the budget. If heat sits at 6% and the ceiling is 8%, the most you can add is 2% of equity in total new risk. Divide that dollar amount by the stop distance to get the maximum share count. The [position sizing guide](/blog/position-sizing-r-multiples-risk-management) walks through the formula, and a wider stop means fewer shares for the same dollar risk.

Review heat again after any stop change, any new position, and at the open after earnings season starts for names you hold. Tighter stops lower heat but also raise the chance of being shaken out by ordinary volatility, so the stop itself should come from structure and [ATR-based placement](/blog/swing-trading-stop-loss), not from the heat target alone.

## Common Heat Mistakes

Most heat errors come from the same few habits. The checklist below contrasts them with the practice that prevents each one.

- ✅ Calculate open risk from the current stop, so trailed stops free up budget
- ✅ Set a lower heat ceiling in choppy and weak regimes than in strong ones
- ✅ Count positions in the same industry group or theme as one cluster
- ✅ Write down your ceiling before the session, not after a losing streak
- ❌ Widening a stop to keep a loser alive, which raises heat without adding a share
- ❌ Adding a new position without checking total open risk first
- ❌ Treating a 1% per-trade rule as a total-risk rule
- ❌ Ignoring gap risk when positions are held through earnings

*EasySwing screens for swing setups automatically and gives every candidate entry, stop, and target levels, so the open risk of a new idea is visible before you consider it. Pair heat limits with [position sizing and R-multiples](/blog/position-sizing-r-multiples-risk-management), the [market regime gate](/blog/market-regime-bull-bear-choppy), and a [trade journal](/blog/swing-trading-journal) to keep total risk in check. Scan results are for informational purposes only. See our [Risk Disclaimer](/disclaimer).*


---
*This is the LLM-optimized version. [View the interactive page](https://easyswing.trading/blog/portfolio-heat-swing-trading) for the human-friendly version.*
